MN-500 Recovery Micro Code

Hello,
I have an MN-500 router that recently had its power light
stay yellow instead of its usual green. This happened
after the power went out. It is now not distributing DHCP
addresses. I had to manually enter an IP address in my
computer (192.168.2.5) in order to get to the Router
setup page, but the setup page states 'Recovery Micro
Code' and asks me to browse to a file for an upgrade.

I have downloaded the MSBNDownload.exe and extracted the
MN-500 .dlf file and attempted to upgrade it using that,
but it says that the upgrade failed. The router power
light now blinks consistantly green and yellow.

I have tried this multiple times using the MN-500 .dlf
file, and have never used any other firmware (so the
software on the router should be fine).

Do you have any ideas as to what could be causing this,
and a way to fix it?

Thank you.

power cycle the unit. maybe try hard reset.

>-----Original Message-----
>Hello,
>I have an MN-500 router that recently had its power
light
>stay yellow instead of its usual green. This happened
>after the power went out. It is now not distributing
DHCP
>addresses. I had to manually enter an IP address in my
>computer (192.168.2.5) in order to get to the Router
>setup page, but the setup page states 'Recovery Micro
>Code' and asks me to browse to a file for an upgrade.
>
>I have downloaded the MSBNDownload.exe and extracted the
>MN-500 .dlf file and attempted to upgrade it using that,
>but it says that the upgrade failed. The router power
>light now blinks consistantly green and yellow.
>
>I have tried this multiple times using the MN-500 .dlf
>file, and have never used any other firmware (so the
>software on the router should be fine).
>
>Do you have any ideas as to what could be causing this,
>and a way to fix it?
>
>Thank you.
>.
>