Linksys wrt54g with HyperWRT cannot telnet wl command

Ciar0468 · 10-25-2009, 10:52 AM

Hi, I am new to telneting to routers, but I need to do it as part of a project.
I have the wrt54g with hyperwrt frimware. I need to telnet in through a wondows command line and use the wl commands.
I can manage to telnet into router, but no wl commands will work. The telnet connection hangs and is non responsive after entering a wl command.
I think that there could be a problem with my configuration setting on the router, but I have no idea where to start. I have been googling for two days with no answers. Any help is greatly appreciated.

Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help my Linksys WRT54G router was broken into using the "curl" command	Debbie Hurley	Wireless Internet	59	07-14-2007 05:42 PM
Providing multiple command line (telnet) interfaces to control an application	Steve Strobel	Linux Networking	1	06-26-2007 09:41 PM
Linksys compability w/ HyperWRT	Ed	Wireless Internet	2	03-08-2005 10:41 PM
Sveasoft or hyperwrt Firmware?	LT	Wireless Internet	1	12-08-2004 08:56 PM
Hyperterminal vs command line telnet	Joe Bramblett, KD5NRH	Linux Networking	10	07-25-2004 04:57 PM