Linksys WAP-11 V2.2 Autosensing Ethernet crossover

Thanks for reading this.

I just got around to flashing the firmware in a WAP-11 V2.2, and afterwards
realized that I had done it with a "straight" ethernet cable connected to my
switch. The flash went OK, and I see the new version number and can program
the WAP-11 with no problem.

I then took the AP back to another computer, where it was connected with a
crossover cable, and it worked fine there, too. I switched the crossover
cable with a straight cable, and it still worked fine.

Is this autosense capability for the Ethernet port documented anywhere? Is
it limited to V2.2?

TIA.

Bill

--
William Warren
(Filter noise from my return address for direct replies)