Networking Forums

Networking Forums > Computer Networking > Broadband > ISDN Feature question

Reply
Thread Tools Display Modes

ISDN Feature question

 
 
Netcom mbickers
Guest
Posts: n/a

 
      04-06-2005, 11:33 AM
I'm currently investigating the replacement and enhancement of telephony and
data services across three small offices which are geographically close (
well! within a 10 mile radius anyway) but on three different BT exchanges.

This for a charity, so funding is very limited.

There is a need for a few numbers to be diverted to whichever office key
members of the management team are currently at.

I see a number of possible solutions:

1) Centrex.

OK. but BT will only deliver on a single exchange. NTL say they can
deliver as one Centrex, but! Track record?

2) DDI numbers on central PBX. Most small switches only support 'push'
divert, not found one with 'Pull' divert. Even then we pay for the diverted
'leg' of the call and many switches do it by 'tromboning' over two lines

3) Using Non Geographic Numbers.
OK. But a number of problems. (see current long running debate in this
forum?)


4) And here is the question! I seem to recall an ISDN feature which will
allow the initial 'target' number to reject the incoming call and respond
with an alternative number for the network to deliver the call to.

So, the question is. Is the feature I've outlined above really exist, or is
it a feature so high on my wish list that I've made it 'real'? If such a
feature does exist, what is the correct terminology to use to trigger
reponses from potential suppliers? What does it cost? What prevents
fraudulent or malicious numbers to be used in the diverted leg?

Apologies in advance for any mis-use of terms in the above.

Any other suggestions as possible solutions also welcome.

Thanks

Maurice



 
Reply With Quote
 
 
 
 
Mark Undrill
Guest
Posts: n/a

 
      04-07-2005, 10:47 AM
Netcom mbickers wrote:
> I'm currently investigating the replacement and enhancement of
> telephony and data services across three small offices which
> are geographically close ( well! within a 10 mile radius
> anyway) but on three different BT exchanges.
>
> This for a charity, so funding is very limited.
>
> There is a need for a few numbers to be diverted to whichever
> office key members of the management team are currently at.
>

<snip>
>
> Any other suggestions as possible solutions also welcome.
>
> Thanks
>
> Maurice


Have you thought of simply using the Call Diversion service. It
is possible, at extra cost, to remotely set, cancel and change
the diversion.

You may also like to look into BTs FeatureLine service. This
would allow you to transfer calls between offices if required.
FeatureLine includes Call Diversion.

We have three offices spread around the UK and find the above
works really well.

HTH

Mark


 
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
ISDN Feature question (Retract) Netcom mbickers Broadband 0 04-06-2005 11:37 AM
ISDN to ADSL Faceplate Question Jeff Gaines Broadband 8 11-28-2004 10:27 PM
MN-100 feature Bob Broadband Hardware 2 06-27-2004 04:42 PM
Simple ISDN question Joe Cocker Broadband 11 05-12-2004 09:43 PM
no ISDN device available error messg after switching from modem to isdn card (SuSE 9.0 Prof) Stefan Bischof Linux Networking 0 04-18-2004 08:46 AM



1 2 3 4 5 6 7 8 9 10 11