IP Configuration only shown in command line

Hi there,

i have a Dell PowerEdge 1950 with ISA Server 2006 SP1 installed on it. The
Server has 2 physical adapters: the onboard network card and a quad port NIC
from intel.

If I try to assign an IP address to a teamed adapter, for example Team #0
(consists 2 ports from the intel NIC), the settings are not shown in the
graphical user interface after clicking OK and reopen the window again. -->
setting shown is standard = DHCP.
With the command "ipconfig" the right settings are shown.

Does anyone know a simular problem?

regards,

Frank

We need more details to help. Posting the result of ipconfig /all may help.

--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com
"Wimmer, Frank" <(E-Mail Removed)> wrote in message
news:7A8F6AA7-483F-4096-B2EA-(E-Mail Removed)...
> Hi there,
>
> i have a Dell PowerEdge 1950 with ISA Server 2006 SP1 installed on it. The
> Server has 2 physical adapters: the onboard network card and a quad port
> NIC from intel.
>
> If I try to assign an IP address to a teamed adapter, for example Team #0
> (consists 2 ports from the intel NIC), the settings are not shown in the
> graphical user interface after clicking OK and reopen the window
> again. --> setting shown is standard = DHCP.
> With the command "ipconfig" the right settings are shown.
>
> Does anyone know a simular problem?
>
> regards,
>
> Frank