Initial MN500 Configuration

Greg

Guest

Posts: n/a

02-09-2004, 08:58 PM

I am not able to complete inital configuration using the
wizard. It seems to hang. I mangaged to confifure the
wireless portion and it works fine. I can can connect
using the Cable modem fine. But when I connect the
router to the Cable modem either with ethernet cable or
wireless I can't get to the internet.

The cable modem has a native IP address. I can't figure
out what is wrong.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Initial problems	bwesley8	Wireless Internet	12	04-21-2006 02:26 PM
Initial value of ssthresh	Alaa	Linux Networking	0	07-11-2005 12:18 PM
512k or 2Mb for initial set-up?	SLP	Broadband	8	08-05-2004 08:51 PM
Using MN500 as Access Point w/ existing MN500	JT	Broadband Hardware	0	05-19-2004 12:36 PM
WEP Wifi Configuration with mn500	Peter Murphy	Broadband Hardware	5	03-05-2004 05:23 PM