ICS is off and reset base still not working

I disabled the firewall in windows, and have no other
firewalls installed. I reset the base station and it
still will not allow the base to be programed. Any
ideas??

HHHEEELLLPPP PPPLLLEEEAAASSSEEE

Go into your browser and the default 192.168.2.1 (unless you changed it)
using the default "admin" without the quotes password. The front end
software isn't necessary. If you post again, please indicate which base
station you're using and on what operating system.
--
Chris H.
Microsoft Windows MVP
Associate Expert
Expert Zone - www.microsoft.com/windowsxp/expertzone

"Dan" <(E-Mail Removed)> wrote in message
news:132901c3fba7$021756a0$(E-Mail Removed)...
>I disabled the firewall in windows, and have no other
> firewalls installed. I reset the base station and it
> still will not allow the base to be programed. Any
> ideas??
>
> HHHEEELLLPPP PPPLLLEEEAAASSSEEE

OK I put in the 192.168.2.1 and the password. What am I
suposed to do now? I have the MN-500 running windows xp


DAN
>-----Original Message-----
>Go into your browser and the default 192.168.2.1 (unless
you changed it)
>using the default "admin" without the quotes password.
The front end
>software isn't necessary. If you post again, please
indicate which base
>station you're using and on what operating system.
>--
>Chris H.
>Microsoft Windows MVP
>Associate Expert
>Expert Zone - www.microsoft.com/windowsxp/expertzone
>
>"Dan" <(E-Mail Removed)> wrote in
message
>news:132901c3fba7$021756a0$(E-Mail Removed)...
>>I disabled the firewall in windows, and have no other
>> firewalls installed. I reset the base station and it
>> still will not allow the base to be programed. Any
>> ideas??
>>
>> HHHEEELLLPPP PPPLLLEEEAAASSSEEE
>
>
>.
>