Ibm 2210

Hi everyone,

I really need some help with this one.
I recently received a ibm 2210 24e router (old)
This router has 2 10BaseT Connections, and 4 WAN,
and console port.

I want to use this router in my network so i be able to play a little
bit with it.

Initial config wanted:

cable modem->d-link 614+ router ->(in dmz on d-link)ibm 2210
router->server

later (when i'm not a complete noob anymore):

cable modem->d-link 614+ router->(in dmz on d-link)ibm 2210 router
connected with a dce/dte cable to a cisco 2501 router->(from
cisco)server

Now for the initial configuration i tried already many hour without
succes
all the router needs to do is forward the data from eth0 to eth1.

can anyone tell me what i need to do for this?
If possible give me the exact commands


thxs a lot in advance
Lorre

I do not remember the commands, but:

http://www.networking.ibm.com/suppor...0docs?OpenView

is a link to docs for it. The commands should be there.

Lorre wrote:
> Hi everyone,
>
> I really need some help with this one.
> I recently received a ibm 2210 24e router (old)
> This router has 2 10BaseT Connections, and 4 WAN,
> and console port.
>
> I want to use this router in my network so i be able to play a little
> bit with it.
>
> Initial config wanted:
>
> cable modem->d-link 614+ router ->(in dmz on d-link)ibm 2210
> router->server
>
> later (when i'm not a complete noob anymore):
>
> cable modem->d-link 614+ router->(in dmz on d-link)ibm 2210 router
> connected with a dce/dte cable to a cisco 2501 router->(from
> cisco)server
>
> Now for the initial configuration i tried already many hour without
> succes
> all the router needs to do is forward the data from eth0 to eth1.
>
> can anyone tell me what i need to do for this?
> If possible give me the exact commands
>
>
> thxs a lot in advance
> Lorre