HP 2626 layer 3 switch

Can anyone explain to me how to do the following configuration on a HP 2626
layer 3 switch?

VLAN1 switch IP ADDRESS 10.0.0.4
VLAN2 switch IP ADDRESS 192.168.5.3

I want to configure the routing on this switch to allow computers on VLAN1
only ports to be able to route to computers that are on VLAN2 only ports but
I am not sure how to configure the routing on this switch. Any help
appreciated thanks.

You can not talk between networks except through a trunk line to a router.
The following is how to setup a cisco router to accept and allow
communications between networks and a switch. Not sure what you are using.

router(config)# int fa 0/0
router(config-if)#no shut
router(config-if)#int fa 0/0.1
router(config-if)#encapsulation dot1q 1
router(config-if)#ip address 10.0.0.4 255.255.255.0
router(config-if)#int fa 0/0.2
router(config-if)#encapsulation dot1q 20
router(config-if)#ip address 192.168.5.3 255.255.255.0
router(config-if)#exit



"Gerry Armstrong" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> Can anyone explain to me how to do the following configuration on a HP
> 2626 layer 3 switch?
>
> VLAN1 switch IP ADDRESS 10.0.0.4
> VLAN2 switch IP ADDRESS 192.168.5.3
>
> I want to configure the routing on this switch to allow computers on VLAN1
> only ports to be able to route to computers that are on VLAN2 only ports
> but I am not sure how to configure the routing on this switch. Any help
> appreciated thanks.
>