Hello everyone,
I just installed a WMP11 in my PC and it is very very unstable. I keep
losing connection every minute or so and I need to reconnect to the
nectwork. I'm at the point where I'm about to go back to the good old
cables.
At this time the WAP is sitting on top of the PC where the WMP11 is
located... so there's about 30 inches between them! I don't get it. I will
try to move the WAP to its intended location which is on top of a high
armoire so I should gain coverage but I get the feeling the WMP11 will act
even worst. I need to add that the PC sits on the floor.
Did I just get a shity card or is my actual setup a potential cause? Any
suggestions?
Thanks!
|
Similar Threads
Linear Mode
