Hi, I have a problem when trying to connect me by GPRS with my laptop.
I run Mandrake cooker. All seems work, as you can see by the snapshots
below, but I cannot ping anything (neither dns, correctly setup in
resolv.conf) but my local address.
I have googled a lot, I found similar posts but nothing really useful for
solving my problem. Any idea?
Regards
Matteo
My kernel routing...
route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.6.6.6 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
0.0.0.0 10.6.6.6 0.0.0.0 UG 0 0 0 ppp0
When I run gprs...all seems work, right?
gprs
Chiusura di Bluetooth: [ OK ]
Avvio Bluetooth: [ OK ]
Press CTRL-C to close the connection at any stage!
defining PDP context...
rAT
OK
ATH
OK
ATE1
OK
AT+CGDCONT=1,"IP","internet.wind","",0,0
OK
Serial connection established.
using channel 75
Using interface ppp0
Connect: ppp0 <--> /dev/rfcomm0
rcvd [LCP ConfReq id=0x0 <auth pap> <mru 1500> <asyncmap 0xa0000>]
Looking for secret in /etc/ppp/pap-secrets for client wind server (null)
Looking for secret in /etc/ppp/chap-secrets for client wind server (null)
sent [LCP ConfReq id=0x1 <asyncmap 0x0> <magic 0xa205e9cf>]
sent [LCP ConfRej id=0x0 <auth pap>]
rcvd [LCP ConfRej id=0x1 <magic 0xa205e9cf>]
sent [LCP ConfReq id=0x2 <asyncmap 0x0>]
rcvd [LCP ConfReq id=0x1 <mru 1500> <asyncmap 0xa0000>]
sent [LCP ConfAck id=0x1 <mru 1500> <asyncmap 0xa0000>]
rcvd [LCP ConfAck id=0x2 <asyncmap 0x0>]
sent [IPCP ConfReq id=0x1 <addr 0.0.0.0> <ms-dns1 0.0.0.0> <ms-dns3
0.0.0.0>]
sent [CCP ConfReq id=0x1 <deflate 15> <deflate(old#) 15>]
rcvd [IPCP ConfReq id=0x0 <addr 10.6.6.6>]
sent [IPCP ConfAck id=0x0 <addr 10.6.6.6>]
rcvd [LCP ProtRej id=0x0 80 fd 01 01 00 0c 1a 04 78 00 18 04 78 00]
rcvd [IPCP ConfNak id=0x1 <addr 212.141.118.120> <ms-dns1 212.245.255.2>
<ms-dns3 212.141.84.12>]
sent [IPCP ConfReq id=0x2 <addr 212.141.118.120> <ms-dns1 212.245.255.2>
<ms-dns3 212.141.84.12>]
rcvd [IPCP ConfAck id=0x2 <addr 212.141.118.120> <ms-dns1 212.245.255.2>
<ms-dns3 212.141.84.12>]
local IP address 212.141.118.120
remote IP address 10.6.6.6
primary DNS address 212.245.255.2
secondary DNS address 212.141.84.12
Script /etc/ppp/ip-up started (pid 11904)
Script /etc/ppp/ip-up finished (pid 11904), status = 0x0
my network interfaces
ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:722 errors:0 dropped:0 overruns:0 frame:0
TX packets:722 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:67227 (65.6 Kb) TX bytes:67227 (65.6 Kb)
ppp0 Link encap:Point-to-Point Protocol
inet addr:212.141.118.120 P-t-P:10.6.6.6 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:4 errors:1 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:102 (102.0 b) TX bytes:66 (66.0 b)
My gprs file, the situation does not change even uncommenting noipdefault
and ipcp-accept-local
cat gprs
# File:
# gprs
#
# Description:
# Serial cable, IrDA, Bluetooth and USB pppd options for GPRS phones.
# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach
# Debug info from pppd:
# Comment this off, if you don't need more info
debug
# Show password in debug messages
show-password
# Connect script:
# scripts to initialize the GPRS modem and start the connection,
# wvdial command is for Orange SPV while other phones should work with chat
connect /etc/ppp/peers/gprs-connect-chat
#connect "/usr/bin/wvdial --chat --config /etc/ppp/peers/gprs-wvdial.conf
#radiolinja_usb_orange_spv"
# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/peers/gprs-disconnect-chat
# Serial device to which the GPRS phone is connected:
# /dev/ttyS0 for serial port (COM1 in Windows),
# /dev/ircomm0 for IrDA,
# /dev/ttyUB0 for Bluetooth (Bluez with rfcomm running) and
# /dev/ttyUSB0 for USB
#/dev/ttyS0 # serial port one
#/dev/ttyS1 # serial port two
#/dev/ircomm0 # IrDA serial port one
/dev/rfcomm0 # Bluetooth serial port one
#/dev/ttyUSB0 # USB serial device, for example Orange SPV
# Serial port line speed
115200 # fast enough
#57600 # perhaps usefull with IrDA
# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
crtscts # serial cable, Bluetooth and USB
#nocrtscts # IrDA
# Ignore carrier detect signal from the modem:
local
# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else
#:10.0.0.1
# pppd must not propose any IP address to the peer!
#noipdefault
# Accept peers idea of our local address
#
#Non era commentata
#
#ipcp-accept-local
# Add the ppp interface as default route to the IP routing table
defaultroute
# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns
# ppp compression:
# ppp compression may be used between the phone and the pppd, but the
# serial connection is usually not the bottleneck in GPRS, so the
# compression is useless (and with some phones need to disabled before
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp
# The phone is not required to authenticate:
noauth
# Username and password:
# If username and password are required by the APN, put here the username
# and put the username-password combination to the secrets file:
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP
# authentication. See pppd man pages for details.
# Example, Radiolinja operator pap-secrets:
# "rlnet" * "internet" *
user "wind"
# Asyncmap:
# some phones may require this option.
#asyncmap 0xa0000
# No magic:
# some phones may require this option.
#nomagic
# Require PAP authentication:
# some phones may require this option.
#require-pap
Similar Threads
Linear Mode
