generic settings for wireless bridge

trying to configure a Cisco 1242AP as a wireless bridge:
is there a list of generic settings available that one can use to make wireless access
points from different manufactures work together? In my particular case I'm trying to
configure a Cisco AG1242 Access Point as a wireless bridge to connect to a Belkin F5D7130
V.2115UK Access Point. I know my way around the inside of the Cisco, but I don't know what
settings I should enter into the Cisco for other access points to accept a connection from
it. I wrote to belkin support about this but their reply said they only support wireless
bridging to and from other belkin devices. I don't know whether this is due to deliberate
design restriction or whether the tech support staff are just too dumb to know about such
settings. I have several access points but using the Cisco1242 I can't wireless bridge to
any of them except of course, my other Cisco 350AP. I was told to seek out any generic
settings that may apply to non-Cisco devices. Thanks for any pointers.

~ trying to configure a Cisco 1242AP as a wireless bridge:
~ is there a list of generic settings available that one can use to make wireless access
~ points from different manufactures work together? In my particular case I'm trying to
~ configure a Cisco AG1242 Access Point as a wireless bridge to connect to a Belkin F5D7130
~ V.2115UK Access Point. I know my way around the inside of the Cisco, but I don't know what
~ settings I should enter into the Cisco for other access points to accept a connection from
~ it. I wrote to belkin support about this but their reply said they only support wireless
~ bridging to and from other belkin devices. I don't know whether this is due to deliberate
~ design restriction or whether the tech support staff are just too dumb to know about such
~ settings. I have several access points but using the Cisco1242 I can't wireless bridge to
~ any of them except of course, my other Cisco 350AP. I was told to seek out any generic
~ settings that may apply to non-Cisco devices. Thanks for any pointers.

The reality is that the "wireless bridge" functionality is undefined by the 802.11
specifications. Therefore, in practice, it may be the exception rather than the rule
for one manufacturer's "wireless bridge" product to successfully associate to another's
access point.

For the Cisco AP1242 - you can try to configure it as a client of the Belkin AP thus
(note, you will need to be running 12.4(3g)JA IOS or above):

interface Dot11radio<n>
station-role workgroup-bridge universal H.H.H

where H.H.H is the MAC address of the wired client behind the AP1242 (this mode supports
only one such client.)

You will also need to configure the SSID, the crypto method, the authentication method
and the credentials as needed (outside the scope of this posting.)

The generic solution to the need to support an abitrary topology behind a wireless client
that is associated to an arbitrary standard access point, is to have that wireless client
be a router that performs NAT on behalf of the network behind it. The Cisco 871W can
do this.

Aaron