eth0 not coming up on boot, but comes up manually

brian

Guest

Posts: n/a

06-08-2005, 02:38 PM

I'm having in issue with the eth0 interface does not come up at boot
time. I get a message during the bootup saying:

Could not get a valid interface name: -> skipped

However, once the box is up, an ifup eth0 works just fine. I'm running
Suse Enterprise 8.0. Can anyone shed some light on this?

Thanks,
Brian

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
e1000 driver won't load at boot, but loads OK manually. Why?	stevenb9643	Linux Networking	4	03-30-2007 10:52 PM
pppoe if fails on boot but not when manually activated	William Gill	Linux Networking	5	11-22-2005 12:37 AM
Hack causes server IP address to exist on my network - stops eth0 from coming up	gee	Linux Networking	3	08-25-2004 04:58 PM
MN710 USB not coming up on boot up	LoneGolfer	Broadband Hardware	0	06-01-2004 08:50 PM
eth1 not coming up at boot time	shuffle	Linux Networking	0	11-03-2003 09:45 PM