For some time I have been connecting two networks together using 2 DLink
2000AP (Hardware revision A1) in bridge mode. The connection works fine for
some time, 20 minutes to several hours, but then one or both of the bridges
will not recognize the other. If one or both are reset by recycling the
power they link for a time. Obviously this is not anyway to run a wireless
network, so DLINK techs tell me that they will swap me the new DWL 2000AP
revision B1 for my intermittent APs. The question is has anyone used the DWL
2000AP's in bridge mode and have connected for, well, forever hopefully?
--
BoB
|
Similar Threads
Linear Mode
