Disabling NAT on MS Base Station?

I am trying to get the base station to be part of another network.

See my post at
http://www.johnbatdorf.net/blog/Wire...oneHelpMe.aspx

I also have a complete diagram of my network, and the problem I'm
trying to solve.

Any help is appreciated.

<(E-Mail Removed)> wrote in message
news:(E-Mail Removed) ups.com...
>I am trying to get the base station to be part of another network.
>
> See my post at
> http://www.johnbatdorf.net/blog/Wire...oneHelpMe.aspx
>
> I also have a complete diagram of my network, and the problem I'm
> trying to solve.
>
> Any help is appreciated.
>

Log into the base station, go to "Security" and then select "Base Station
Mode" and select the "Access Point" designation. This will remove NAT, DHCP
(which you should be getting from the linksys) and the firewall.

Select "Apply" and then log off.
-Pete

PS: The instructions are for the MN-700. Not sure if they would work with
other MS wireless routers.

-Pete

The principles are still the same (i.e. set the router into 'bridge' mode)

--
Jason Tsang - Microsoft MVP

Find out about the MS MVP Program -
http://mvp.support.microsoft.com/default.aspx

"Pete Delgado" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> PS: The instructions are for the MN-700. Not sure if they would work with
> other MS wireless routers.
>
> -Pete
>