D-Link DI-614+ Rev A firmware with all 14 channels?

I have a D-Link DI-614+ Rev A and want to open up all 14 channels
like the Japanese version. I haven't had any luck navigating the
Japanese D-Link site yet.

Has anyone else tried this or know of other countries that allow all
the channels?

TIA
Dave

P.S. I'm not too concerned about ruining the router, it's a good
excuse to get a newer faster one ;-)

"Dave" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> I have a D-Link DI-614+ Rev A and want to open up all 14 channels
> like the Japanese version. I haven't had any luck navigating the
> Japanese D-Link site yet.
>
> Has anyone else tried this or know of other countries that allow all
> the channels?
>
> TIA
> Dave
>
> P.S. I'm not too concerned about ruining the router, it's a good
> excuse to get a newer faster one ;-)

The Aussie version has 13 channels:
http://www.dlink.com.au/tech/drivers...ets/di614+.htm

I use a 11 channel client on it and it works fine. I think channel numbers
are negotiated in infrastructure mode aren't they? The only problem I can
think of would be in peer-peer mode if you had one on channel 13 and
couldn't set the other 11 channel client to that channel.

Haven't mucked around with this much though.

I always wonered why DLink called this a 614, now I realise the 14 refers to
14 channels. Maybe should have been 611 in the US?


-KENT