how to config mn500 with existing router

02-25-2004, 04:24 PM

I have a netgear router, the cable modem is plugged into
it. the mn500 doesnt seem to work unless i take the router
completely out of the picture, not going to happen. Will
this thing work with a router or not?

02-25-2004, 06:13 PM

You need to configure the MN-500 (While not connected to the other
router) then put it in bridge mode.

dave wrote:
> I have a netgear router, the cable modem is plugged into
> it. the mn500 doesnt seem to work unless i take the router
> completely out of the picture, not going to happen. Will
> this thing work with a router or not?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Adding Modem/Router device to existing network with wireless router?	Bob	Network Routers	0	07-01-2007 11:28 PM
Adding a wireless router to an existing network with Cisco router	Michael Erb	Wireless Internet	12	04-05-2006 01:26 AM
Adding DSL to existing wireless network but in different room than existing router?	costasz@gmail.com	Wireless Internet	0	08-12-2005 05:07 PM
Using MN500 as Access Point w/ existing MN500	JT	Broadband Hardware	0	05-19-2004 12:36 PM
Config Help for Linksys Router on Existing Network, please	Jacob Burnetski	Wireless Internet	0	08-08-2003 12:50 PM