Cisco AP-1230 network-map issue

Hi,

We have 5 Cisco AP-12XX, running the latest IOS-version in our
network. Three of them are connected on switch 'A' and two of them are
connected on another switch 'B'.

When I issue 'sh dot11 network-map' on any of the AP's on switch 'A',
I get a nice overview, but incomplete. The AP's that are connected on
switch 'B' are missing from the network-map output.

Also, the 'sh dot11 network-map' command on any of the AP's connected
to switch 'B' fail. They do not even 'see' eachother.

The AP's are not to far from eachther, so that is not the problem.
Also, 'dot11 network-map' is configured on all AP's. It must have
something to do with them being on another switch. IP-wise everything
is fine. I can ping all AP's, they also can ping eachother. They are
all in the same VLAN.

Anyone got a clue?

--
Marco

Marco Davids wrote:


> Anyone got a clue?

Solved it myself; the AP's where configured to use VLAN's, but the
switchport was not in trunkmode. Apparently this mistake also has an
influence on the network-map.

--
Marco