Can't connect to the internet with Linksys WRT54G

Wanting to move from "B" to "G", I have just attempted to connect to
the internet with a new Linksys WRT54G router and am having problems
connecting to the internet. I have been using a BEFW11S4 without
problems. I have manually setup the new router using the same setup
config as the BEFW11S4 and am having problems. What am I doing wrong?
TIA, Keith

kb <(E-Mail Removed)> wrote in
news:(E-Mail Removed):

> Wanting to move from "B" to "G", I have just attempted to connect to
> the internet with a new Linksys WRT54G router and am having problems
> connecting to the internet. I have been using a BEFW11S4 without
> problems. I have manually setup the new router using the same setup
> config as the BEFW11S4 and am having problems. What am I doing wrong?
> TIA, Keith
>

What IP is the computer getting? If the IP starts with the 169 IP, the
O/S cannot get an IP from the DHCP server on the router and is timing out
assigning the IP to the NIC. The IP will allow the computer to access the
machines on the LAN but it will not allow the computer to access the
Internet, since it never got an IP from the router. WPA -- WEP keys are
not valid, not using B or G, MAC access, bad router and bad card could be
some of the issues. One poster had a mis-config card something about
duplex-ing was the problem -- I don't know.

You just might want to get on the phone with Linksys. They are good for
something.

Duane

On Sat, 01 Oct 2005 20:47:17 -0700, kb <(E-Mail Removed)> wrote:

>Wanting to move from "B" to "G", I have just attempted to connect to
>the internet with a new Linksys WRT54G router and am having problems
>connecting to the internet. I have been using a BEFW11S4 without
>problems. I have manually setup the new router using the same setup
>config as the BEFW11S4 and am having problems. What am I doing wrong?
>TIA, Keith

1. Take the wireless out of the picture temporarily and do your
testing with a wired connection to the router. Setup the wireless
after you get a connection to the internet. Check the status page to
see if you have a connection to your ISP.

2. If your unspecified ISP uses the MAC address of the client for
authentication, you may need to "clone" the MAC address of the old
router (manually). This is common with cable modem setups. Whenever
you make changes to the MAC addresses, power cycle everything
including the cable/dsl/satellite modem.
--
Jeff Liebermann (E-Mail Removed)
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558