How can you reset the Sitecom WL-105b to Factory Default

Hello,

Today, I tried to upgrade the firmware of my accesspoint WL105b from
sitecom. Something seemed to go wrong because i got an error message, but
configuring was still possible
After resetting my accesspoint nothing worked anymore.

Does anybody know how I can restore my old settings or a backdoor way to
default factory settings?

Thanks in advance,
Marcel

I have tried the WL-105b without much success, so I returned it and
bought a similar Belkin one.
If I remember well you have to press the reset long enough until a led
starts to flash rapidly, this causes a return to factory settings.
It is mentioned in the manual or setup guide.

SiteCom.nl has very good and friendly support by email.

--

Eric P. van Westendorp Tel: +31(0252)210579
Reigerslaan 22 2215NN Voorhout Netherlands

Mars wrote:
> Hello,
>
> Today, I tried to upgrade the firmware of my accesspoint WL105b from
> sitecom. Something seemed to go wrong because i got an error message, but
> configuring was still possible
> After resetting my accesspoint nothing worked anymore.
>
> Does anybody know how I can restore my old settings or a backdoor way to
> default factory settings?
>
> Thanks in advance,
> Marcel
>
>
>