Boot Problem booting while second hard drive is attached!

I had only one Seagate SATA 160GB hard drive installed until yesterday
when I acquired another hard drive (Seagate SATA 200GB). I have Vista
running on my first hard drive and decided I would load Vista onto my
second hard drive for when I move it to my other computer. Only problem
is after the installation the computer would not boot. I disconnected
the second hard drive and the first hard drive booted up just fine. I
then plugged in the second hard drive and searched for new hardware. The
second drive appeared and I formatted it. So, now it is completely
cleaned and empty. I restart and my computer does not even get past
loading the BIOS. I can't even enter setup utility. If I unhook the
second hard drive's data cable, computer boots up just fine. I checked
MSCONFIG and there is only the one Vista OS running off the first drive
and is set as default. Please help. Thanks.


------------------------------------------------------------------------
View this thread: http://www.wirelessforums.org/showthread.php?t=37608
http://www.wirelessforums.org

"teflontoad" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
>
> I had only one Seagate SATA 160GB hard drive installed until yesterday
> when I acquired another hard drive (Seagate SATA 200GB). I have Vista
> running on my first hard drive and decided I would load Vista onto my
> second hard drive for when I move it to my other computer. Only problem
> is after the installation the computer would not boot. I disconnected
> the second hard drive and the first hard drive booted up just fine. I
> then plugged in the second hard drive and searched for new hardware. The
> second drive appeared and I formatted it. So, now it is completely
> cleaned and empty. I restart and my computer does not even get past
> loading the BIOS. I can't even enter setup utility. If I unhook the
> second hard drive's data cable, computer boots up just fine. I checked
> MSCONFIG and there is only the one Vista OS running off the first drive
> and is set as default. Please help. Thanks.
>
>
> ------------------------------------------------------------------------
> View this thread: http://www.wirelessforums.org/showthread.php?t=37608
> http://www.wirelessforums.org
>

On the drives - do you have the right jumper settings - master / slave?