BEFW11S4 setup wizard fails

I just installed Linksys BEFW11S4 - wireless router -B
It seems to work fine - however I could not get Setup Wizard to
complete. After setting TCP/IP settings (and rebooting) - the Wizard
pops up a message saying click yes to reboot and continue or No to go
back and set TCP/IP settings. I click yes - it reboots and comes back
to same place - over and over again... I click No and it won't
continue. It seems wizard is checking something and won't continue
unless it's correct - but I don't know what.
I have a Netgear FA311 card and a Linksys USB ethernet connection. I
checked ipconfig and both show DHCP is set. I have Windows ME on IBM
Netvista.

Any help would be appreciated!
Thanks
Ed

sabino56 <(E-Mail Removed)> writes:

> I just installed Linksys BEFW11S4 - wireless router -B
> It seems to work fine - however I could not get Setup Wizard to
> complete. After setting TCP/IP settings (and rebooting) - the Wizard
> pops up a message saying click yes to reboot and continue or No to go
> back and set TCP/IP settings. I click yes - it reboots and comes back
> to same place - over and over again... I click No and it won't
> continue. It seems wizard is checking something and won't continue
> unless it's correct - but I don't know what.
> I have a Netgear FA311 card and a Linksys USB ethernet connection. I
> checked ipconfig and both show DHCP is set. I have Windows ME on IBM
> Netvista.

I have that same AP... and it could be that you're just done with the
wizard. The wizard is kinda limited--if you've got functionality,
poke around in the actual menus instead. Be sure to set up WEP if
you're interested in keeping snoopers off your local network. I don't
know if there's WPA firmware available for that AP yet.

--
Todd H.
http://www.toddh.net/