Networking Forums

Networking Forums > Wireless Networking > Wireless Internet > antenna

Reply
 
 
shawn@phatspot.com
Guest
Posts: n/a

 
      07-18-2006, 07:01 PM
I have a wireless G setup with a linksys router. I used to use a range
extender but it gave me problems so I would just like to put a super
powerful antenna on my router. Can this group reccomend something to
me. Thanks

 
Reply With Quote
 
 
 
 
dold@XReXXanten.usenet.us.com
Guest
Posts: n/a

 
      07-18-2006, 09:30 PM
(E-Mail Removed) wrote:
> I have a wireless G setup with a linksys router. I used to use a range
> extender but it gave me problems so I would just like to put a super
> powerful antenna on my router. Can this group reccomend something to
> me. Thanks


How much of a range extension do you need?
How super powerful does this antenna need to be?

I like the http://www.freeantennas.com EZ-12 Windsurfer, but you might want
http://www.nodomainname.co.uk/parabolic/parabolic.htm
or maybe
http://www.nodomainname.co.uk/parabolic/parabolic.htm
both based on the EZ-10.


--
---
Clarence A Dold - Hidden Valley Lake, CA, USA GPS: 38.8,-122.5
 
Reply With Quote
 
Kevin T. Neely
Guest
Posts: n/a

 
      07-18-2006, 09:51 PM
On 2006-07-18, (E-Mail Removed) <(E-Mail Removed)> wrote:
> I have a wireless G setup with a linksys router. I used to use a range
> extender but it gave me problems so I would just like to put a super


CompUSA sells the "Cantenna", which I find pretty funny. You can make
it for something like $5 after a trip to Lowes (hardware), RadioShack
(electrics), and the Grocery Store (can of Pringles), but it's like
$30 at the store.
This type of antenna would be used for extending your range in a
particular direction, like to reach a friend's house or nearby coffee
shop.

Linksys sells some longer antennae that connect to their router/AP
models.

good luck, and let us know what works best!
K

--
http://astroturfgarden.com
 
Reply With Quote
 
shawn@phatspot.com
Guest
Posts: n/a

 
      07-19-2006, 03:16 AM
I am on the 4th floor and need it to go straight down to the 1st. It
makes it to the second. I would rather buy one then build. Should I get
the cantenna ?

 
Reply With Quote
 
Kevin T. Neely
Guest
Posts: n/a

 
      07-19-2006, 03:40 AM
On 2006-07-19, (E-Mail Removed) <(E-Mail Removed)> wrote:
> I am on the 4th floor and need it to go straight down to the 1st. It
> makes it to the second. I would rather buy one then build. Should I get
> the cantenna ?


Trying to go down through floors is very difficult. The signal will likely
die trying to go through the brick, wires, pipes, concrete, etc. that
will get in its way. If the person is directly below you, I recommend
going out the window, down, and then back in from his window.

A directional antenna like the cantenna would be what you need. You lose
signal gain (is that the right terminology) by using panel or omni-
directional antennae.

hope that helps.
K


--
--
http://astroturfgarden.com
 
Reply With Quote
 
Chuck Olson
Guest
Posts: n/a

 
      07-19-2006, 05:41 AM

<(E-Mail Removed)> wrote in message
news:(E-Mail Removed) oups.com...
> I am on the 4th floor and need it to go straight down to the 1st. It
> makes it to the second. I would rather buy one then build. Should I get
> the cantenna ?
>


The Cantenna is an excellent choice, but a Pringles can is just a bit too
small in diameter. You would do better with a 3.25" inside diameter can from
26oz Bush's Beans or Del Monte Spaghetti Sauce. Some of the Campbell's soups
come in a large 26oz can, also. You can buy the cheapest or you can buy what
you prefer to eat - - your choice.

You have to drill a hole in the side of the can exactly 2.49" from the
bottom end of the can. The diameter of the hole depends on the connector you
have. For a single-hole BNC or Type N, use 3/8", and if you have a taper
reamer, it's best to start small and ream it to size.

Then you need to solder a wire into the center pin of the connector - - use
any solid wire that you can find from 14 to18 gauge (I like to use the wire
lead on an old but unused 2-watt resistor). Cut any convenient length over
1.5" and solder it in, then cut it so that only 1.31" projects straight up
out of the metal body of the connector - - that's 1/4-wave at 2.4GHz. Then
bolt the connector into the hole in the side of the can and connect up the
cable to your router. Point the open end to where you expect the signal and
see if that doesn't improve the hookup. Don't use a very long cable, or else
all the good work the antenna does will be undone by losses in the cable.

Good luck,

Chuck W6PKP


 
Reply With Quote
 
 
 
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Connect Flat panel Antenna with a Parabolic Antenna gfts Wireless Internet 4 11-08-2005 03:57 PM
Antenna Booster for Wireless Routers--can Linksys antenna or Hawking be used with any router? Patty Amas Wireless Internet 6 12-02-2004 09:52 PM
Hawking HAI15SC HiGain Directional Corner Antenna 15dBi 2.4GHz Antenna John Mason Wireless Internet 0 09-09-2004 11:15 AM
Antenna Delima-WRTG54g Outside Antenna has 2 Antennas? !Lou Wireless Internet 1 09-10-2003 11:29 PM
Which is the Best CHEAP PC CARD which accepts external antenna? Which antenna to use? Arawak Wireless Internet 7 08-12-2003 01:31 AM



1 2 3 4 5 6 7 8 9 10 11