I haven't used routing before. So, you can take my comments or not.
It sounds like you must set routing mode to 'router.' Then, you must
configure your router to do the router you require. I suspect that you
may require static routing, but am not certain. Instructions from
RV042 user manual follow. Sorry can't be more helpful -- as with
actual experience with this issue. I began to set up routing once, but
found a way around it before I had it working.
Static Routing
You will need to configure Static Routing if there are multiple routers
installed on your network. The static routing function determines the
path that data follows over your network before and after it passes
through the Router.
You can use static routing to allow different IP domain users to access
the Internet through this device. This is an advanced feature. Please
proceed with caution.
This Router is also capable of dynamic routing (see the Dynamic Routing
tab). In many cases, it is better to use dynamic routing because the
function will allow the Router to automatically adjust to physical
changes in the network's layout. In order to use static routing, the
Router's DHCP settings must be disabled.
To set up static routing, you should add routing entries in the
Router's table that tell the device where to send all incoming packets.
All of your network routers should direct the default route entry to
the Linksys Router.
Enter the following data to create a static route entry:
1. Destination IP: Enter the network address of the remote LAN segment.
For a standard Class C IP domain, the network address is the first
three fields of the Destination LAN IP, while the last field should be
zero.
2. Subnet Mask: Enter the Subnet Mask used on the destination LAN IP
domain. For Class C IP domains, the Subnet Mask is 255.255.255.0.
3. Default Gateway: If this Router is used to connect your network to
the Internet, then your gateway IP is the Router's IP Address. If you
have another router handling your network's Internet connection, enter
the IP Address of that router instead.
4. Hop Count (max. 15): This value gives the number of nodes that a
data packet passes through before reaching
its destination. A node is any device on the network, such as switches,
PCs, etc.
5. Interface: (LAN, WAN1, WAN2/DMZ) Interface tells you whether your
network is on the LAN or the WAN, or the Internet. If you're
connecting to a sub-network, select LAN. If you're connecting to
another network through the Internet, select WAN.
Click Add to list to add a route entry or click Delete Selected IP to
delete the static route entry.
Click the Save Settings button to save the Routing settings, click the
Cancel Changes button to undo your changes or click the Show Routing
Table button to view the current routing table.
|
Similar Threads
Linear Mode
