adapter not connected?

I am using a Netgear wireless modem router DG834PN 108 wireless b/g MIMO, I
have three pc's and one laptop that are using a 128bit wireless encrypted
network however one of the pc's (using a netgear rangemax usb 2.0 adapter
keeps telling me that my device is not connected even though it is plugged
into the back of the pc and the blue light is flashing. when I run the
software, it picks up the network and gives a strong signal then it drops
the signal and carries on scanning again and again. I have enabled access to
this pc in the access settings of the router but still it says that it is
not connected. I have used ipconfig and it says that media is disconnected,
what do I do?

You have said that you have enabled access to this pc in the access settings
of the router. That sounds like you are using a MAC access control list as a
security settings. On this pc I'd suggest that you go | Start | Run | CMD
{Enter} | ipconfig /all | and compare the Physical Address listed to what
you have enter in the wireless router, sometimes the printed value on a card
is wrong. It sounds to me as if you have a security value set wrong.

--
David Hettel

Please post any reply as a follow-up message in the news group for everyone
to see. I'm sorry, but I don't answer questions addressed directly to me in
E-mail or news groups.

Microsoft Most Valuable Professional Program
http://mvp.support.microsoft.com

DISCLAIMER: This posting is provided "AS IS" with no warranty of any kind,
either expressed or implied, made in relation to the accuracy, reliability
or content of this post. The author shall not be liable for any direct,
indirect, incidental or consequential damages arising out of the use of, or
inability to use, information or opinions expressed in this post and confers
no rights.



"T5" <(E-Mail Removed)> wrote in message
news:Og$(E-Mail Removed)...
>I am using a Netgear wireless modem router DG834PN 108 wireless b/g MIMO, I
>have three pc's and one laptop that are using a 128bit wireless encrypted
>network however one of the pc's (using a netgear rangemax usb 2.0 adapter
>keeps telling me that my device is not connected even though it is plugged
>into the back of the pc and the blue light is flashing. when I run the
>software, it picks up the network and gives a strong signal then it drops
>the signal and carries on scanning again and again. I have enabled access
>to this pc in the access settings of the router but still it says that it
>is not connected. I have used ipconfig and it says that media is
>disconnected, what do I do?
>